25.5mmx25.5mm Happymodel CrazyF405HD ELRS AIO 1-2S F4 Flight Controller Built-in 12A BL_S 4In1 ESC Receiver for Mobula8 Digital HD Whoop Toothpick FPV Racing Drone

25.5mmx25.5mm Happymodel CrazyF405HD ELRS AIO 1-2S F4 Flight Controller Built-in 12A BL_S 4In1 ESC Receiver for Mobula8 Digital HD Whoop Toothpick FPV Racing Drone

0 out of 5

$59.99

SKU: POA0277974 Categories: , ,

Description

Introduction:

A flight controller with a builtin Serial ELRS receiver and 4IN1 BL_S 12A ESC specially developed for Digital HD FPV, which removes the analog OSD chip 7456, optimizes the PCB layout, and supports 1-2S Lipo / LiHV lithium batteries, very Suitable for Digital HD Tinywhoop / Cinewhoop / Toothpick and other small FPV drones. 

The flight controller uses the F405 chip, supports Betaflight/INAV firmware, has 3 sets of complete UARTs available, and integrates a BMP280 barometer and 8Mbp blackbox, which greatly enhances the playability of the flight controller.

Specification:

Brand: Happymodel

Model: CrazyF405HD

Item Name: F4 Flight Controller AIO 12A 4in1 ESC ELRS Receiver

Mount size: 25.5×25.5mm
Weight: 4.8g (without power lead wire)

Flight Controller MCU: STM32F405RGT6 (168MHZ, 1Mbyte FLASH)
GYRO Sensor: BMI270  (SPI connection)
Mount hole size: 25.5mm*25.5mm
Power supply: 1-2S battery input (DC 2.9V-8.7V)
Built-in 12A(each) Blheli_S 4in1 ESC
Built-in Serial ExpressLRS 2.4G
Built-in BMP280 Barometer
Built-in 8MBp blackbox
Built-in voltage meter sensor , voltage meter scale 110
Built-in current meter sensor , current meter scale 470
Onboard 4in1 ESC Power supply: 1-2S LiPo/LiPo HV
Current: 12A continuous peak 15A (3 seconds)
Support BLHeli_S Bluejay firmware
Factory firmware: Bluejay ESC V0.19
Firmware target: Z-H-30
Default protocol: DSHOT300
When use 1s battery and high KV 0702/0802 motors, should set startup power to 1100/1200
Onboard UART ExpressLRS 2.4GHz Receiver Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz
RF Frequency: 2.4GHz
Antenna: enameled copper wire 31mm length
Telemetry output Power: <12dBm
Default firmware version: ExpressLRS V3.0.1
Firmware target: HappyModel EP 2400 RX
Could update firmware via ExpressLRS configurator

Pacakge Included:

1x Happymodel CrazyF405HD Board

1x Cable Connector  

4x Anti-vibration Ball 

4x Screws

Additional information

Weight 0.005 lbs
Model

Flight Controller

Related Products